VMA-C260U F4U CORSAIR 60 SEMI SCALE ARF - USMC
HORIZONTAL STABILIZER & ELEVATOR SPECIFICATIONS
Location Slot in Fuselage        
Span Tip to Tip 22 in. 559  mm
Area Without Elevator 69 sq in 445  sq cm
Airfoil Slab        
Dihedral na        
Polyhedral na        
Taper Leading Edge Yes      
Taper Trailing Edge No      
Chord At Root 4.5  in. 114  mm
Chord At tip end Elevator 2.75  in. 70  mm
Thickness Maximum 0.313  in. 8  mm
Material Wood        
Method Built Up        
Sheeted Fully No      
Ribs Capped Yes      
Covering Factory Applied Yes      
Covering Type Film      
Covering Heat Shrinkable Yes Low Temp  
Covering Repairable Yes Soft Cloth & Gun
Elevators Installed Yes      
Elevators Type Split 2    
Elevators Pinned in place Yes      
Elevators Hinges/Elevator 3      
Elevator  Hinges Metal Pin Yes      
Elevator Servo in Fuselage Yes 1    
Elevator Area 18 in. 457  mm
Elevators Factory Joined No Stay Split  
Horiz Stab Struts na      
Mounting Use 30min Epoxy and Slot in Fuse
Markings Top No      
Markings Bottom No      
* Color Top vs Bottom Not Same    
* Color Top Primary M Blue      
* Color Top Trim na      
* Color Top Lines    Gray      
* Color Top Rivets Gray      
* Color Bottom Primary L Blue      
* Color Bottom Trim M Blue      
* Color Bottom Lines Gray      
* Color Bottom Rivets Gray      
NOTES:
Accuracy of Dimensions provided here is within 3% in production
"na" =  not applicable
"?" = estimated and yet to be confirmed
Colors May vary within and between production runs
M Blue = Midnight Blue
L Blue = Light Blue
Blk = Black
Area of Horiz Stab includes wing saddle area but not Elevator
Copyright Richmond RC Supply Ltd 2002 02 17