| 1 | Part#: | VMA-F690XSPK |
20070222 00004624 |
| 6 | Spinner Material: | Metal |
20070127 00004629 |
| 7 | Spinner Color: | Black |
20070127 00004630 |
| 8 | Spinner Shape: | Elongated Cone |
20070127 00004631 |
| 9 | Spinner Length from back of Backing Plate to front tip of Nose: | 4.25 in. (108 mm) |
20070127 00004632 |
| 10 | Spinner Diameter of Backing Plate: | 3.07 in. (78 mm) |
20070127 00004633 |
| 11 | Spinner Mounting System: | Please See Note |
20070128 00004634 |
| The spinner backing plate is slid over the crankshaft and placed into contact with the engine thrust washer. The propeller and prop washer are then fitted next and retained into place with the elongated prop nut supplied with the spinner. The prop nut is then cinched down tightly. The spinner cone is then fitted so that the edge of the open end of the cone fits and is constrained from radial movement by the groove that runs around the perimeter of the front face of the backing plate. The supplied hex head machine screw is then used to secure the cone. | |||
| 12 | Spinner Prop Nut Length: | 2.62 in. (66.5 mm) |
20070127 00004635 |
| 13 | Spinner Prop Nut Diameter: | .55 in. (14 mm) |
20070127 00004636 |
| 14 | Spinner Prop Nut Tightens via: | Flats on Side of Nut |
20070127 00004637 |
| 15 | Spinner Prop Nut Thread for Crankshaft: | 5/16 x 24 |
20070127 00004638 |
| 16 | Spinner Prop Nut Threaded to accept Screw to attach Cone: | Yes |
20070127 00004639 |
| 17 | Spinner Length of Screw to attach Cone: | 1.18 in. (30 mm) |
20070127 00004640 |
| 18 | Spinner Diameter of Screw to attach Cone: | .16 in. (4 mm) |
20070127 00004641 |
| 19 | Spinner Crankshaft Collett Supplied: | Yes. 1 Brass |
20070127 00004642 |
| 20 | Spinner (complete) Weight: | .224 lbs (102 g). |
20070127 00004643 |