| 1 | Part#: | VMA-F590XSPK |
20071031 00008113 |
| 6 | Spinner Material: | Metal |
20070321 00008118 |
| 7 | Spinner Color: | Black |
20070321 00008119 |
| 8 | Spinner Shape: | Elongated Cone |
20070321 00008120 |
| 9 | Spinner Length from back of Backing Plate to front tip of Nose: | 4.25 in. (108 mm) |
20070321 00008121 |
| 10 | Spinner Diameter of Backing Plate: | 3.07 in. (78 mm) |
20070321 00008122 |
| 11 | Spinner Mounting System: | Please See Note |
20070321 00008123 |
| The spinner backing plate is slid over the crankshaft and placed into contact with the engine thrust washer. The propeller and prop washer are then fitted next and retained into place with the elongated prop nut supplied with the spinner. The prop nut is then cinched down tightly. The spinner cone is then fitted so that the edge of the open end of the cone fits and is constrained from radial movement by the groove that runs around the perimeter of the front face of the backing plate. The supplied hex head machine screw is then used to secure the cone. | |||
| 12 | Spinner Prop Nut Length: | 2.62 in. (66.5 mm) |
20070321 00008124 |
| 13 | Spinner Prop Nut Diameter: | .55 in. (14 mm) |
20070321 00008125 |
| 14 | Spinner Prop Nut Tightens via: | Flats on Side of Nut |
20070321 00008126 |
| 15 | Spinner Prop Nut Thread for Crankshaft: | 5/16 x 24 |
20070321 00008127 |
| 16 | Spinner Prop Nut Threaded to accept Screw to attach Cone: | Yes |
20070321 00008128 |
| 17 | Spinner Length of Screw to attach Cone: | 1.18 in. (30 mm) |
20070321 00008129 |
| 18 | Spinner Diameter of Screw to attach Cone: | .16 in. (4 mm) |
20070321 00008130 |
| 19 | Spinner Crankshaft Collett Supplied: | Yes. 1 Brass |
20070321 00008131 |
| 20 | Spinner (complete) Weight: | .224 lbs (102 g). |
20070321 00008132 |